Epoxy Flooring in Elma, NY

Epoxy flooring in Elma covers more than the attached garage. The town spans about 34.5 square miles with 11,721 residents at the 2020 census. Housing is spread out, with about 124.5 units per square mile in the 2000 count. Many properties have room for a detached workshop, a pole barn or an equipment garage. Those floors work hard, and they are often the ones owners call us about.

Shops and outbuildings

Elma has deep working roots. The area was settled around 1827, and the town's name comes from the post office set up for a local lumber mill in 1852. Wikipedia notes that buffalo are now raised on several local farms, and aerospace company Moog Inc. is also in town.

A concrete shop or barn floor deals with tractors, mowers, trailers, fuel and fertilizer. Commercial and shop floor epoxy stands up to that:

• Thick 100% solids base coats for heavy loads
• Chemical-resistant topcoats for oil, fuel and cleaners
• Added texture where floors get wet and slick

Older outbuilding slabs are often rough, cracked or uneven. Concrete crack and floor repair comes first, so the coating sits on a sound surface.

The home garage

For the house garage, a garage floor coating or epoxy flake floor handles salt and slush from winter roads. Flake hides dirt and adds grip. If you need the garage back quickly, polyaspartic floor coating cures faster than standard epoxy.

Creeks and basements

Buffalo Creek runs west through the northern part of town, and Cazenovia Creek flows north through the southwest part. Homes on lower ground near either one can have damper basements. Before we recommend basement floor epoxy, we test the slab. If moisture is high, we use a primer made for it or tell you to fix the water problem first.

Across the hamlets

We work throughout the town: Elma Center, Jamison Road, East Elma, Spring Brook along Route 16 and Blossom in the northwest corner, once the main site of the Ebenezer Society. Wherever you are, the job starts the same way, with a visit to look at the floor.

Living with a coated shop floor

A sealed shop floor sweeps clean, and spills wipe up instead of soaking in. Dropped parts are easier to spot on a lighter floor. Rolling tool carts and creepers move more easily on a smooth, hard surface. Use pads under jack stands, keep a spill kit handy for fuel, and sweep grit out regularly so it does not grind into the topcoat.

Planning a job on a larger property

On a spread-out property, we often coat more than one building. A common job here is the house garage plus a detached shop or barn floor. We can quote them together and schedule them back to back.

A few things help us plan:

• Power. Our grinders need steady power. Tell us if a barn or shop has limited outlets.
• Access. Let us know if a building is down a long gravel drive or across a field.
• Heat. Unheated outbuildings need warm weather for the coating to cure, so we book them for late spring through early fall.
• Use. Tell us what the floor carries: a tractor, a trailer, a lift, livestock feed or chemicals. That decides the system.

We give you one written quote with each floor listed separately, so you can do them all at once or one at a time. Call (716) 576-3587 to set up a visit.

Get a Free Estimate