Epoxy Flooring in Kenmore, NY

Epoxy flooring in Kenmore is a job of tight spaces and old concrete. The village was incorporated in 1899 out of the Town of Tonawanda and is known as Buffalo's First Suburb. It covers only about 1.44 square miles, and the 2020 census put its density at about 10,590 people per square mile. That is very dense for a suburb. Lots are small, driveways are narrow and many garages are compact.

Why small garages need a careful plan

A small garage leaves less room for error. There is no corner where a rough edge will go unnoticed, and the car parks in the same tire tracks every day. A few things matter more here:

1. Edge work. We grind right up to the walls and around the door frame so the coating bonds everywhere, not just in the middle. 2. Crack repair. Old slabs in narrow garages often crack along their length. We fill and grind those flush with concrete crack and floor repair before any coating goes down. 3. Cure time. If the garage is your only covered parking, polyaspartic floor coating gets the car back inside sooner. 4. Grip. An epoxy flake floor adds texture, which helps when you are stepping around a car in a tight space on a wet day.

Basements in older homes

The village has been residential for well over a century, so many basements are old. Over the years they have collected paint, patching and old floor tile glue. Some are used for laundry, storage or a workshop. Others are being finished as living space.

We test moisture before we recommend basement floor epoxy. Old basement slabs often sit right on the soil with no vapor barrier. If the reading is too high, a coating will lift. When the slab passes, a sealed floor is easier to mop, stays brighter and holds less dust.

Getting equipment in and out

With narrow driveways and close neighbors, we plan how the grinder, dust collector and materials will reach your garage or basement before the job day. We use dust collection while grinding and clean up at the end of each day.

Storefronts and back rooms

Delaware Avenue, which runs north and south through the village, carries much of the local commercial traffic. Back rooms, storage spaces and small service areas behind storefronts can use commercial and shop floor epoxy for a floor that cleans up quickly.

Old patches and uneven spots

Century-old slabs here often carry patches from several owners. Some are softer than the concrete around them. Some sit a little high or low. We grind high spots down, cut out weak patches and refill them with a repair material made to bond with old concrete. The goal is one flat, sound surface before the first coat.

What a Kenmore estimate covers

We measure the floor, including any step or landing you want coated. We test moisture, mark cracks and note old paint, sealer or glue. You get a written quote that names the system, lists each prep step and each coat, and gives one total. There are no add-ons sprung on you the day of the job.

In a dense village, scheduling matters too. We tell you how many days the garage or basement will be out of use and when the noisiest part, the grinding, will happen. If you share a driveway, it helps to let your neighbor know which days we will be there. We keep our vehicles and equipment out of the way as much as we can, and we clean up at the end of each day.

Call (716) 576-3587 or request an estimate below to set a time.

Get a Free Estimate