Epoxy Flooring in Tonawanda, NY

Epoxy flooring in Tonawanda covers two very different kinds of concrete. Most of the town was built out as suburban housing in the 1940s and 1950s, so neighborhoods like Brighton, Kenilworth, Green Acres and Sheridan Parkside are full of garages and basements from that period. Out west, the industrial area along River Road and the Niagara River holds a different kind of floor: plant, warehouse and shop slabs that see real work.

We coat both. Here is how we approach each one.

Homes from the 1940s and 1950s

A garage slab from this era has had decades of winter use. The common problems:

• Scaling and pitting near the door from salt brine
• Cracks running across the slab, sometimes with one side slightly higher
• Old paint or sealer that has partly worn through
• Oil stains that have soaked deep into the surface

Our standard approach is concrete crack and floor repair followed by a garage floor coating. Many owners choose an epoxy flake floor because the chips hide salt residue and give a bit of texture underfoot. If you need the garage back quickly, polyaspartic floor coating cures faster than standard epoxy.

For basements, we test the slab before we recommend basement floor epoxy. Older basements often have higher moisture, and a coating on a wet slab will bubble and peel.

Industrial floors near the river

The town has a long industrial history along River Road. Wikipedia names DuPont's plant at Sheridan Drive and River Road and the Tonawanda Coke foundry coke producer on River Road among the businesses there. Floors in this part of town carry forklifts, pallet jacks and chemical spills.

Commercial and shop floor epoxy for these spaces uses thicker 100% solids systems. We grind the slab, repair joints and damaged areas, and pick a topcoat for the chemicals and traffic the floor actually sees. We can also plan the job in sections so part of the floor stays in use.

Questions to ask yourself first

How do you use the garage? A floor that holds two cars and a lawn mower needs a different finish than one that doubles as a woodshop. Do you park inside all winter? Then plan for salt, and lean toward flake. Is the basement finished or headed that way? Then the moisture test decides what goes down. Answering these before the estimate helps us give you a quote that fits.

A typical residential job, step by step

1. Clear and inspect. You empty the garage. We walk the slab, mark cracks and test moisture. 2. Grind. We diamond grind the whole floor, edges included, with dust collection running. 3. Repair. Cracks are opened and filled. Pitted spots near the door are patched. Everything is ground flush. 4. Base coat. The first layer goes down and soaks into the open concrete. 5. Flake or color. For a flake floor, chips are spread until no base shows. 6. Topcoat. A clear protective layer seals it all. 7. Cure. We give you written times for walking, moving things back and parking.

On most two-car garages this runs over one to two days, depending on the system and the weather. Basements follow the same order, with a moisture-tolerant primer where the test calls for it. If anything about the scope changes once we start, we write it up and you approve it before we go on.

Get a Free Estimate

Before we start

We visit, measure, check moisture and look at the condition of the concrete. You get a written quote listing the prep, each coat and the total. If anything changes once work begins, we write it up for your approval first.